Insert Ncu 7X0 In Hw Config - Siemens SINUMERIK 804D sl Commissioning Manual

PLC commissioning
7.1 Creating a SIMATIC S7 project
Figure 7-2
7.1.3

Insert NCU 7x0 in HW config

Introduction
The user interface of "HW config" mostly displays (see the following figure):
• Station window:
• Hardware catalog
Use the operator input sequence steps described below to insert an NCU 720.1 as example.
Operating steps
1. Select "View > Catalog".
2. Search for the module in the catalog under "SIMATIC 300 > SINUMERIK > 840D sl >
44
HW-Config
The station window is split. The upper part displays the structure of the station
graphically, and the lower part provides a detailed view of the selected module.
In this catalog, the NCU 7X0 that you need for configuring the hardware is also included.
NCU 720.1" (see following figure).
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0