Hyundai EQUUS 2016 Owner's Manual page 152

Operating HomeLink
To operate, simply press and release
the programmed HomeLink
Activation will occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For
convenience, the hand-held transmit-
ter of the device may also be used at
any time.
Reprogramming a single
®
HomeLink button
To program a new device to a previ-
ously trained HomeLink
low these steps:
1. Press and hold
HomeLink ® button. Do NOT release
until the step 4 is completed.
2. When the indicator light begins to
flash slowly (after 20 seconds),
point the handheld transmitter 1 to
3 inches away
HomeLink ® surface.
3. Press and hold the handheld
transmitter button. The HomeLink
indicator light will flash, first slowly
and then rapidly.
4. When the indicator light begins to
flash rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink ® button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
Convenient features of your vehicle
®
Erasing HomeLink
An individual programming cannot
®
button. be erased. However, to erase all
three programmings;
1. Press and hold the two outer
HomeLink
cator light begins to flash after 20
seconds; and
2. Release both buttons. Do not hold
for longer than 30 seconds.
The Integrated HomeLink
Control System is now in the training
(learning) mode and can be pro-
grammed at any time by following the
® button, fol- appropriate
"Programming".
the desired FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
from the
®
®
buttons
® buttons until the indi-
® Wireless
steps as in the
3-57
03