Hyundai EQUUS 2016 Owner's Manual page 144

3. Simultaneously press and hold
both the HomeLink ®
transmitter buttons
HomeLink ® indicator
from slow flashing to rapid flash-
ing. Now you may release both the
®
HomeLink and hand-held trans-
mitter buttons.
i
Information
Some devices may require you to
replace this Programming step 3 with
procedures noted in the "Gate
Operator/Canadian Programming"
chapter. When the HomeLink
tor does not change to rapid flashing
after performing these steps, contact
HomeLink ® at www.homelink.com.
4. Firmly press, hold for 5 seconds
and release the programmed
HomeLink ® button up to two sep-
arate times to activate the door.
When the door does not activate,
press and hold the just-pro-
grammed HomeLink
observe the indicator.
• When the indicator remains illu-
minated, programming is com-
plete.Your device will activate by
pressing and releasing the
®
HomeLink button.
• When the indicator flashes rapid-
ly for 2 seconds and then turns to
a constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code-equipped device (most
commonly a garage door open-
er).
Convenient features of your vehicle
5. At the garage door opener receiv-
and handheld er (motor-head unit) in the
until the garage, find the "learn" or "smart"
changes button. This can usually be found
where the hanging antenna wire
is attached to the motor-head
unit.
6. Firmly press and release the
"learn" or "smart" button. (The
name and color of the button vary
by manufacturer). Wait for 30 sec-
onds before starting the step 7.
7. Return to the vehicle. Firmly
press and hold the programmed
HomeLink
®
indica-
Then release it. Repeat this
"press/hold/release" sequence
for the second time. Depending
on the brand of the garage door
opener (or other rolling code
equipped device), repeat this
sequence for the third time to
complete
process.
HomeLink
®
button and
rolling code equipped device.
® button for 2 seconds.
the programming
® should now activate your
03
3-49