Hyundai EQUUS 2016 Owner's Manual page 145

Convenient features of your vehicle
Gate operator & Canadian
programming
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink
Control System button (refer to the
steps 2 to 3 in the Programming part)
while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal is learned. The indicator
light will flash slowly and then rapidly
after a few seconds when success-
fully trained.
Operating HomeLink
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained devices (i.e. garage door
opener, gate operator, security sys-
tem entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
3-50
Reprogramming a single
HomeLink
To program a device to HomeLink
using a HomeLink
ly trained, follow these steps:
® Wireless
1. Press and hold the desired
HomeLink
release the button.
2. The indicator light will begin to
flash after 20 seconds. Without
releasing the HomeLink
proceed to the "Programming"
step 2.
For more questions or comments,
contact HomeLink
®
link.com or 1-800-355-3515.
®
button.
Erasing HomeLink
An individual programming cannot
be erased respectively. However, all
three programming can be erased at
the same time by following below
steps;
1. Press and hold the two outer
HomeLink
cator light begins to flash after 10
seconds.
2. Release both buttons. Do not hold
for longer than 20 seconds.
The Integrated HomeLink
Control System is now in the training
(learning) mode and can be pro-
grammed at any time by following the
appropriate
"Programming".
FCC ID: NZLTLMHL4
IC: 4112A-TLMHL4
®
button
®
button previous-
®
button. DO NOT
®
button,
® at www.home-
®
buttons
® buttons until the indi-
®
Wireless
steps as in
®
the