Troubleshooting; Specifications - Denon SYS-1312 Owner's Manual

Troubleshooting

If a problem should arise, fi rst check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner's manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem
persist, there may be a malfunction.
In that case, disconnect the power immediately and contact your place of purchase.
Symptom
Subwoofer • AC power plug is not securely
(DSW-1312): connected.
Indicator does not
light and no sound
is produced when
power is turned on.
Subwoofer • Cables are not securely
(DSW-1312): connected.
Indicator lights • Volume adjustment control is
but no sound is turned all the way down.
produced. • Protective circuit has been
activated due to excess input or
rise in temperature.
Subwoofer • Volume level is too high.
(DSW-1312):
Sound is distorted.
• Sound is being distorted on
connected amplifi er.
Subwoofer • Volume of subwoofer or
(DSW-1312): amplifi er set too high.
Oscillation (loud
continuous sound).
Volume does not • The subwoofer is connected
adjust in sync to a terminal other than the
with volume of amplifi er's SUBWOOFER
amplifi er. PREOUT connector (to
terminals with a set output
level).
1.SYS1312_EM_ENG_00A.indd Sec1:5 1.SYS1312_EM_ENG_00A.indd Sec1:5
All manuals and user guides at all-guides.com
Cause Countermeasure
• Check the connection of the AC
power plug.
• Connect securely.
• Turn the control and set it to the
desired position.
• Set the power switch to the
"OFF" position, wait at least
1 minute, then set the power
switch back to the "ON"
position.
If the problem persists, unplug
the power cord from the AC
power outlet and contact your
place of purchase.
• Turn the volume adjustment
control counterclockwise to
lower the volume.
• Do not amplify the bass sound
on the amplifi er. (Lower the
amplifi er bass adjustment
control or volume.)
• Lower the volume of the
subwoofer or amplifi er.
• Connect the subwoofer to
the amplifi er's SUBWOOFER
PREOUT connector.
Specifi cations
n Front speaker and surround speaker (SC-F1312)
Type:
Drive units:
Input impedance:
Max. input:
Frequency range:
Dimensions:
Page
Weight:
4
n Center speaker (SC-C1312)
Type:
Drive units:
Input impedance:
Max. input:
4
Frequency range:
3, 4
Dimensions:
Weight:
–
n Subwoofer (DSW-1312)
Type:
Drive unit:
Frequency range:
Dynamic power:
Input impedance:
Power supply:
3, 4
Power consumption:
Dimensions:
–
Weight:
* For improvement purpose, specifi cations and design are subject to change without notice.
3, 4
–
Full-range 1-speaker
Closed box
8 cm cone full range x 1
6 Ω
60 W (IEC)
120 W (PEAK)
150 Hz – 20 kHz
105 (W) x 200 (H) x 150 (D) mm (4-9/64" x 7-7/8" x 5-29/32")
0.8 kg (1 lbs 12 oz)
Full-range 1-speaker
Closed box
8 cm cone full range x 1
6 Ω
60 W (IEC)
120 W (PEAK)
150 Hz – 20 kHz
200 (W) x 105 (H) x 150 (D) mm (7-7/8" x 4-9/64" x 5-29/32")
0.8 kg (1 lbs 12 oz)
Refl ex box
Built-in amplifi er
20 cm cone woofer x 1
35 Hz – 150 Hz
100 W
22 kΩ
120 V / 60 Hz (North American model)
230 V / 50 Hz (European model)
65 W
MAX. 0.5 W (Standby)
250 (W) x 387 (H) x 420 (D) mm (9-27/32" x 15-15/64" x 16-17/32")
11 kg (24 lbs 4 oz)
ENGLISH
5
2011/06/13 1 2011/06/13 1