Appendices; Switcher Firmware Update Procedure - Datavideo HS-1300 Instruction Manual

Appendices

Switcher Firmware Update Procedure

From time to time Datavideo may release new firmware to either add new features or to fix reported bugs
in the current HS-1300 firmware. Customers can update the firmware themselves if they wish or they can
contact their local dealer or reseller for assistance should they prefer this method.
This page describes the firmware update process and it should take approximately few minutes to
complete.
A working HS-1300 requires the following:
 The latest firmware update for the HS-1300 (This firmware file can be obtained from your local
Datavideo office or dealer).
 HS-1300 x 1
 12V Power adapter x 1
 USB thumb drive x 1
 USB A connector cable x 1
Once started the update process should not be interrupted in any way as this could result in a non-
responsive unit.
1. Locate the FW Upgrade USB port on the front panel of the HS-1300.
2. Insert the USB stick containing the latest firmware to the FW upgrade port.
3. Power on the device and the device should automatically detect the connected USB storage device.
4. Press the "MENU" button on the control panel to open the menu on the monitor screen.
5. Press the "down arrow" button to scroll to the "Setup" Option.
6. Press the "ENTER" button to enter the "Setup" menu.
7. Press the "down arrow" button to scroll to "Software" and then press the "ENTER" button to select
the "Software" option.
8. As soon as "Software" is selected, you will be prompted whether to start the Software Upgrade. Select
YES if you would like to start the software upgrade.
9. Reboot the device after the upgrade process is complete.
80