Transition Effect - Datavideo HS-1300 Instruction Manual

Transition Effect

FTB
Fade To Black, this button fades the current video program source to
black. When pressed again it acts in reverse from complete black to
the currently selected program video source.
SPEED
There are three speed buttons which can be defined by the user. By
pressing a speed button the user is choosing the rate of transition or
time taken when using the AUTO TAKE button.
Transition Speed (1, 2 and 3):
Button 1= 12 frame duration, 2= 25 and 3= 50 at 1080i50
Button 1= 15 frame duration, 2= 30 and 3= 60 at 1080i60
PVW TRANS
Transition shown on PVW only.
MIX
This button enables MIX transition effect.
WIPE
This button enables WIPE transition effect. The WIPE button must be
selected when a wipe effect transition between the selected Program
and Preset sources is required. This WIPE effect is produced by moving
the T-Bar manually or pressing the AUTO TRANS button.
CUT
This performs a simple immediate switch from the current main source
to the selected sub source. The selected transition wipe or MIX is not
used.
AUTO TAKE
This performs an automated switch from the current program source
to the selected Preview source. The selected transition wipe or MIX
will also be used. The timing of the transition is set by the chosen
Speed button.
15