Initial Setting - Siemens Sinamics G120P Operating Instructions Manual

Key Function
The INFO key has the following functions:
Display additional information about the currently selected position.
•
Pressing the INFO key again returns to the previous screen.
•
Pressing the INFO key during the IOP ramp-up places the IOP into DEMO mode. To end DEMO mode,
•
switch the IOP off and on again.
The MANUAL/AUTO key is used to switch the command source between MANUAL and AUTO.
MANUAL specifies the IOP as command source.
•
AUTO specifies an external source (e.g. fieldbus) as command source.
•
For further explanations about the settings and menus, see Operation with the IOP
(Page 294).
Locking and unlocking the keypad
Press the ESC and INFO keys together for at least 3 seconds to lock the IOP keypad. Press
the ESC and INFO keys together for at least 3 seconds to unlock the keypad.
5.3.2

Initial setting

Initial setting
Once the IOP has been switched on, it detects automatically the Control Unit and
Power Module type on which it was attached. When the IOP is used for the first time, it
selects automatically the standard language as well as the date and time setting.
After the display of the Initial commissioning screen, the
IOP shows details about the Control Unit and Pow-
er Module type, including the Article numbers.
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A
Commissioning
5.3 Commissioning with the IOP
131