Maytag MXR65 Service Manual page 13

Maintenance every 500 Working
Hours or 3 Months
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
n Observe the washer from the back for one
wash cycle. Be sure that water does not
leak out of the drain during the wash part
of the cycle and that it drains freely at the
beginning of extraction. Clean the drain if
either of these symptoms are observed.
1. Turn off power to washer at the circuit
breaker or fuse box.
2. Check the tightness of the bolts securing
the rear panel of the washer.
3. Check the belt tightness or for belt damage.
(See page 1-8)
4. Check mounting bolt tightness. Retighten if
necessary (fixed installation only).
5. Inspect all hoses and connections inside the
washer for leaks and correct as necessary.
6. Wipe off any stains with a soft cloth
dampened with water or a mild detergent
solution. Be sure that control components
are not exposed to dust and moisture during
cleaning.
7. Put covers back on and check that all bolts
are properly torqued.
8. Turn on power at circuit breaker or fuse box.
Maintenance every 1000 Working
Hours or 6 Months
n Turn off hot and cold water to the washer at
the valves.
n Clean water filters.
n Clean and remove dirt and dust from:
– the inverter cooling fin
– the motor cooling fins
– the inverter internal fan (if present)
– the external fan (if present)
– the external air relieves.
n Make sure the fan in the inverter cool fins (if
present) is functioning.
n Make sure the external fan (if present) is
functioning.
1-7