Maytag MXR65 Service Manual page 113

The computer will begin a specific
routine depending on the failure
type:
n WHEN SAFETY IS INVOLVED
Full stop + tumble:
– The program is stopped but will run the
tumble sequence
Full stop + safety:
– Time the program is stopped and a
safety time is started
Do not start:
– The program will not be started as long
as the safety conditions are not fulfilled
n WHEN SAFETY IS NOT INVOLVED
Full stop + request for continue:
– A request to Continue ? the program is
displayed
Skip + continue:
– The actual cycle step is skipped and the
program continues with the next step
Continue:
– The program continues
Special cases:
n For e11: Fill Time failure and e14:
Heating time failure after overriding and
erasing the Failure Message, restart or
stop the sequence, when "Continue ?" is
displayed.
Possible cause:
– water supply inlets off
– decreasing capacity of heating elements;
or washer does not have heating elements
n Fault 31: initialization Fault inverter
and 32: verification Fault inverter can
be erased by switching off the power.
But as Faults 31 and 32 indicate that the
Frequency Inverter is not loaded with the
correct parameter settings, the washer
can be damaged when the Inverter is
functioning with the incorrect settings.
Before using the washer, have a technician
inspect the problem.
n Fault 41: Service Due will keep occurring
until the cycle counter is reset.
5-3