Tool List - Siemens SINUMERIK 840D sl Operating Manual

Tool management

6.5 Tool list

6.5 Tool list
All parameters and functions that are required to create and set up the tools are displayed in
the tool list.
Each tool is uniquely identified by the tool identifier and the replacement tool number.
Tool parameters
Column heading
Location
* If activated in magazine
selection
Type
Tool name
ST
D
Length
Radius
Tip angle or
Pitch
N
You use the configuration file to specify the selection of parameters in the list.
156
Meaning
Magazine/location number
•
*
•
*
•
Tool type
Specific tool offset data is displayed depending on the tool type
(represented as an icon).
The tool is identified by the name and the replacement tool number. You
may enter the names as text or numbers.
Replacement tool number (for replacement tool strategy)
Cutting edge number
Tool length
Geometry data, length
Tool radius
Tip angle for Type 200 - twist drill and Type 220 - center drill
Pitch for Type 240 - tap
Number of teeth for Type 110 - ball end mill for cylindrical die-sinking
cutter, Type 111 - ball end mill for tapered die-sinking cutter, Type 120 -
end mill, Type 121 - end mill with corner rounding, Type 130 - angle head
cutter, Type 140 - facing tool, Type 150 - side mill, Type 155 - bevel
cutter, Type 156 - bevel cutter with corner rounding, and Type 157 -
tapered die-sinking cutter.
Spindle location as an icon.
Locations for gripper 1 and gripper 2 (applies only when a spindle with
dual gripper is used) as icons.
Magazine location number.
The magazine number is specified first, followed by the location
number in the magazine.
If there is only one magazine, only the location number is displayed.
Operating Manual, 01/2008, 6FC5398-6AP10-2BA0
HMI sl Universal