A display showing "_" means output is off; "*" means output is on.
Press the program button and proceed to PR ASSIST / PRESSURE ASSIST.
1 1 3 3 ) )
Press the UP or DOWN button to toggle between YES / NO. If set to NO, the
1 1 4 4 ) )
pressure assist feature is disabled. If set to YES, press the PROG button (right
arrow) to advance to the PR ASSIST DELAY SECONDS setting.
Set PR ASSIST DELAY SECONDS from 0 to 120 seconds. Press the PROG
1 1 5 5 ) )
button (right arrow) to advance to PR ASSIST NOT NEEDED IF 'X' PSI.
Set PR ASSIST NOT NEEDED IF 'X' PSI from 0.0 to 12.0 psi.
1 1 6 6 ) )
Press the program button to proceed to the next step, or press and hold the
1 1 7 7 ) )
program button to exit Special Programming.
57