Henny Penny 500 Operator's Manual page 31

C C h h a a p p t t e e r r 3 3 O O p p e e r r a a t t i i o o n n a a n n d d
M M a a i i n n t t e e n n a a n n c c e e
3 3 . . 1 1 C C 1 1 0 0 0 0 0 0 P P r r o o g g r r a a m m m m i i n n g g I I n n s s t t r r u u c c t t i i o o n n s s
3 3 . . 1 1 . . 1 1 T T i i m m e e r r P P r r o o g g r r a a m m m m i i n n g g
Anytime the cook time is displayed, press under the appropriate display to change the
cook time.
3 3 . . 1 1 . . 2 2 S S e e t t - - P P r r o o g g r r a a m m m m i i n n g g T T e e m m p p e e r r a a t t u u r r e e P P r r o o g g r r a a m m m m i i n n g g
NOTE: If LOCK displays the controls are locked and must be unlocked. See
C1000 Special Programming , page
Press P once to view the actual shortening temperature and press P again to
1 1 ) )
view the set point temperature.
While the set-point temperature is in the display, press the UP and DOWN
2 2 ) )
arrows to change the set-point temperature.
3 3 . . 2 2 C C 1 1 0 0 0 0 0 0 S S p p e e c c i i a a l l P P r r o o g g r r a a m m m m i i n n g g
Special Programming is used to set:
• Fahrenheit or Celsius
• Initialize System
• Lock or Unlock Controls
• Fryer Type - Open or Pressure
• Heat Source - Electric; Gas w/electronic ignition
• Vat Type - Full or Split
• Oil Type - Solid or Liquid
To enter Special Programming, turn off power switch (either side). Press and
1 1 ) )
hold P and turn the power switch back on.
Use the UP and DOWN arrow to choose "°F" or "°C". "SPEC" "PROG" followed
2 2 ) )
by, "DEG" "°F" or "°C".
Press P and "INIT" shows in the display. Press and hold and display shows "In-
3 3 ) )
3", "In-2", "In-1" followed by "Init Sys" "DONE DONE". The controls now are
reset to factory parameters, the time set to 0:00 and temperature 190°F or 88°C.
Press P and "LOCK" or "UNLOCK" shows in the displays. Use the UP and
4 4 ) )
DOWN arrow to choose "LOCK" or "UNLOCK.
Press P and "FRYR" shows in left display and the right display should show
5 5 ) )
"PRES". Use the UP and DOWN arrow to change from "OPEN" to "PRES" if
needed.
19.
3.2
19