Remove Coin Drop - Pd Model - Maytag MDG25PN Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove service access door from top of
metercase.
2. Remove two 1/4" security bolts from inside
the service access area.
Two 1/4"
Security
Bolts
3. Disconnect wire harness connectors from
coin sensor switch(es) as necessary.
4. Pull coin drop out from the front of the
metercase.

rEMOvE cOin DrOP - PD MODEL

nOTE: When reinstalling the coin drop
make sure that wires connected to the
coin sensor go straight back from the coin
sensor. If wire goes forward it could break
the beam of the coin sensor and show an
error on the UIC.
nOTE: There are 2 female connectors that
accept a coin drop harness. The female
connector that is black in color or has a
black permanent marker scribbled on it is
for coin 2 of a dual coin acceptor. When
a single coin acceptor is used it should be
connected to the coin 1 connector with no
mark on it, or that is white in color when the
other is black.
4-37