Remove Lint Filter Housing; Remove Front Bulkhead - Maytag MDG25PN Service Manual

rEMOvE LinT
FiLTEr HOuSinG
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Open dryer door and remove lint filter.
2. Remove service panel (See page 4-16).
3. On Model 22 dryers release door switch
wire harness strain relief. On Model 25
dryers release the Christmas tree clip from
lint filter housing.
4. Remove four 1/4" hex head screws. The two
screws going into the blower housing are
brass and must be reinstalld in the same
location they are removed from.
5. Pull lint filter housing away from dryer.
TEcH TiP: Excess blower vibration may be
reduced by loosening the upper left brass
screw in the lint filter housing up to two full
turns. Make sure the foam insulation blocks
any gaps, add more foam insulation or
aluminum duct tape to seal up any gaps.
Two 1/4" Hex
Head Screws
Two Brass 1/4" Hex
Head Screws
rEMOvE FrOnT
BuLkHEaD
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove front panel (See page 4-17).
2. Remove lint filter housing (See left column
on this page).
3. Remove two 1/4" hex head screws from
bottom corners of bulkhead.
4. Loosen, but do not remove, two 1/4" hex
head screws from top corners of bulkhead.
5. Lift front bulkhead enough so upper screws
can pass through the lower snowman holes
and pull it away from dryer.
nOTE: After front bulkhead is removed, do
not move the dryer or serious damage may
occur to the side panels.
4-18
1/4" Hex
Head Screws