Maytag MDG25PN Service Manual page 12

Free Cycles
This is established by setting the cycle
price to zero. When this happens 'SELECT
CYCLE' will be displayed rather than the
cycle price. Any cycle started as a free cycle
will automatically terminate when the door is
opened.
Debit card ready
This dryer is debit card 'cable' ready. It will
accept a variety of debit card systems; but,
DOES NOT come with a debit card reader,
and requires replacement of the facia. Refer
to the debit card reader manufacturer for
proper dryer set-up. In models converted with
a Generation 1 debit card system, debit pulses
represent the equivalent of one coin (coin 1).
cOnTrOL SET-uP PrOcEDurES
iMPOrTanT: Read all instructions before
operating.
The fabric setting buttons along with the digital
display are used to set-up the dryer controls.
The display can contain 4 numbers and/or
letters and a decimal point. These are used
to indicate the set-up codes and related code
values available for use in programming the
dryer.
How to use the buttons to program the
controls
1. WHITES AND COLORS button is used to
adjust values associated with set-up codes.
Pressing and releasing button will increment
value by one (1). Rapid adjustment is
possible by holding the button down.
2. The PERM. PRESS button will advance
through the set-up codes. Pressing and
releasing this button will advance to the next
available set-up code. Holding the button
down will automatically advance through the
set-up codes at a rate faster than one (1)
per second.
3. The DELICATES button is used to select or
deselect options.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Start Operating Set-up
n PD models: Insert service access door key,
turn, and lift to remove service access door.
n PN models converted to PR: once a
Gen 2 card reader is installed (according to
the reader manufacturer instructions), the
set-up can only be changed by inserting
a manual set-up card (supplied by the
reader manufacturer) into the card slot.
If a manual set-up card is not available,
manual set-up mode cannot be entered.
However, diagnostic mode can be entered
by removing connector AA1 on the User
Interface Control (UIC) or by using the
Service Access Code. (See page 1-8).
iMPOrTanT: The console must not be
opened unless power is removed from the
dryer. To access connector AA1:
Ë Unplug dryer or disconnect power.
Open console, disconnect jumper on AA1,
Ë
close console.
Ë Plug in dryer or reconnect power.
n PN Models Equipped with Programming
Switch: Insert access panel key and turn
counter-clockwise.
1-6