Replace the Cover
Step 3
Installer to disconnect all cables connected to the system.
Step 4
Place the chassis on a flat surface.
Step 5
Remove the 14x cover screws on the two sides of the router cover. See figure.
Step 6
Slide the cover from bezel side to I/O side until it stops.
Step 7
Pull the cover vertically to disengage from the chassis.
Replace the Cover
To replace the cover, do these steps:
Warning
The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed. Statement 1077.
1 and 2
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
46
Install and Upgrade Internal Modules and FRUs
Replace the 14 screws on either side of the cover.