Reset Button; Power Supply - Cisco 1100-8P Hardware Installation Manual

Reset Button

LED
LTE DATA/SIM
(C1101-4PLTEPWz
C1 101-4PL TEP/C1 101-4PL TEPWx)
WLAN
(C1101-4PLTEPWx)
USB Console
USB 3.0
Reset Button
The actuation of the Reset button is only recognized during ROMMON boot, that is, as the router comes to
the ROMMON prompt.
The Reset button does not require much force to be actuated. The Reset button should be actuated only with
a small implement such as the tip of a pen or a paper clip. When the Reset button is pressed at startup, the
system LED turns green.
For more information, see the "Reset Overview" section of the

Power Supply

Cisco 111x Series ISRs support PoE and PoE+ power to endpoints. The product power specifications are as
follows:
• AC input voltage: Universal 100 to 240 VAC
• Frequency: 50 to 60 Hz
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
12
Color Description
Green and Amber Single LTE Modem (one
modem with SIM
switch-over capability)
Off: Modem not up or
modem up and no SIM
Amber Steady On:
Modem up, SIM installed
but not active.
Green Blink: LTE data
activity.
3-color LED: Green, Red WLAN Functions
& Amber;
Green USB Console Status
OFF: USB console not
active
ON: USB console active
Green USB 3.0 Status
OFF: No USB device
discovered
ON: USB device
discovered
USB activity
Overview of Cisco 1000 Series Integrated Services Routers
Control Source
Bezel Side
I/O
I/O
I/O
Cisco 1100 Software Configuration Guide.