Spirit CRS800 Owner's Manual page 32

ENGINEERING MODE MENU
The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is pressed
for example. To enter the Engineering Mode Menu, press and hold down the Start, Stop and Enter
keys. Keep holding the keys down for about 5 seconds and the Message Center will display
Engineering Mode Menu. Press the Enter key to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. LCD Test (Tests all the display functions)
3. Functions (Press Enter to access settings and Up arrow to scroll)
I. Display Mode (Turn off to have the console power down automatically after 20 minutes of
inactivity)
II. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause
indefinitely)
III. ODO Reset (Resets the odometer)
IV. Motor Test (Continually runs the tensioning gear motor)
V. SAFETY
VI. SENSOR TEST
4. Security (Allows the keypad to be locked to prevent unauthorized use)
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
31
Dyaco Canada Inc. 2016