Restoring Factory Settings - Siemens SIRIUS 3RW5 series Manual

Maintenance and service

8.3 Restoring factory settings

8.3 Restoring factory settings
Effects of the factory setting
The following devices can be reset to the factory setting:
● 3RW5 soft starter
– The parameters of the 3RW5 soft starter are reset to the factory setting
– User accounts are deleted (depending on the 3RW5 soft starter).
– An automatic restart of the 3RW5 soft starter is performed.
● 3RW5 communication module
– The parameters of the 3RW5 communication module are reset.
● 3RW5 HMI High Feature
– The parameters of the 3RW5 HMI High Feature and the PIN for access protection are
● All devices
– The 3RW5 soft starter, the 3RW5 communication module, and the 3RW5 HMI High
Procedure
1. Make sure that the motor is switched off and that you do not start the motor while
restoring the factory settings. Make sure that the main supply voltage is only applied to
the 3RW5 soft starter when it is necessary.
2. Restore the factory settings.
The following procedures are possible:
– Via SIRIUS Soft Starter ES (TIA Portal) over the LAN interface on the 3RW5 HMI High
– Via the 3RW5 HMI High Feature
Result
The factory setting of the selected device or all devices is restored.
66
(depending on the 3RW5 soft starter).
reset to the factory setting.
Feature are reset to the factory settings, as described above.
Feature
You will find more information on operating the 3RW5 HMI High Feature in the Manual
of the 3RW5 soft starter.
SIRIUS 3RW5 Modbus TCP communication module
Manual, 03/2018, A5E43676481002A/RS-AA/001