Data Tables; Byte Arrangement; Specifications; A.2 Data Tables - Siemens SIRIUS 3RW5 series Manual

A.2

Data tables

A.2.1

Byte arrangement

When data longer than one byte are stored, the bytes are arranged as follows ("big endian"):
1 register corresponds to 1 word (2 bytes).
A.2.2

Specifications

The following specifications apply in the data tables:
● Addresses are represented as hexadecimal values.
● The access to undefined addresses is illegal and generates an error message.
● Non-relevant (reserved) entries are not listed.
Fill these entries with "0" when writing.
● In data tables for parameters, codes are shown in square brackets "[...]". "[D*]" describes
the default coding.
Object number (Obj. No.)
The object number (Obj. No.) is used for unique identification of all parameters available in
the 3RW5 soft starter. In the case of a parameterization error, the object number of the faulty
parameter is displayed in data table "Soft starter diagnostics" (Page 82) under
"Faulty parameter number".
SIRIUS 3RW5 Modbus TCP communication module
Manual, 03/2018, A5E43676481002A/RS-AA/001
Appendix

A.2 Data tables

75