Panasonic ER-GC71 Operating Instructions Manual page 12

Trimming to an even length
Holding the clipper with the
power switch facing outwards,
trim slowly while crisscrossing
from various directions to
avoid missing any spots.
Notes
• It is recommended to ask someone else to trim around your own
ears and neckline.
• The desired results may not be achieved if hair is too long. In this
case, trim the hair to a length of about 2 cm (51/64˝) before using
the clipper.
12
Trimming beard
• Do not use with shaving foam applied or when the beard is wet.
A wet beard may stick to the skin or bunch up, making it difficult
to trim.
• Before trimming, comb your moustache with a comb.
Trimming to an even length
Holding the clipper with the power
switch facing outwards, trim by
bringing the blade in contact with
the skin and moving the clipper
against the flow of the beard.
• Hair trimmings may collect inside the comb
attachment when a large volume of beard is
cut, so discard hair trimmings after each use.
Trimming the downy hair
Without comb attachment
Holding the clipper with the power
switch facing outwards, trim by
bringing the blade in contact with
the skin.
• The clipper cannot trim hair to lengths less
than 0.5 mm (1/64˝).