Table of Contents
Advertisement
6.
Before installing the new Linkage Arm, check the diameter of the
small pivot shaft (P) on the Arm Pivot. Use the appropriate hardware in the
Linkage Arm service kit for your machine.
25mm dia. pivot shaft
6.
Installation is the reverse procedure. Put the Right Shroud in position
first to align the screws for the Left Shroud. Install the top screws first.
NOTICE: Be sure the tabs in the Top Shroud snap into the Main
Assembly.
Completely tighten the Cap Screws (A) on the Crank Arms or torque to 60
N . m.
The Left Crank Arm has an "L", the Right Crank Arm an "R.
Orientation is based from a seated position on the bike. Make
sure the Crank Arms are secure before you exercise.
7.
Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
12mm dia. pivot shaft
43
P
A
(60 N . m)
B
C
Hide quick links:
Advertisement
Table of Contents
