Non-Recordable Calls; Enhanced Functions; The Following Features Are Not Supported; Recording Tips - Siemens HIPATH 8000 User Manual

Step by step

Enhanced functions:

1
1. A conference can be set up or cleared down during
recording.
2. A consultation can be performed during recording.
3. Call transfer is also available during recording.
4. A second call can be accepted during recording.

The following features are not supported:

1. Playing back recordings over the telephone.
2. Deleting recordings over the telephone.
3. Functions for editing recordings over the telephone.

Recording tips

You will receive the following advisories while a call is
being recorded:
• The recording symbol
(permanent)
• Beep (repeated at intervals for you and your call
partner)
• Beep (single at the start of recording for you and
your call partner)
The audible advisory can also be switched off. Please
check with the relevant service personnel.

Multiline

In terms of call recording, no distinction is made
between multiline and singleline. If recording has
started, recording is performed, otherwise not. The
recording status of a line persists as long as calls are
connected to this line.
For example, if line A is being recorded (initiated
manually) and you switch to line B or line A is placed on
manual hold and you switch to line B, the recording is
ended and a partial recording saved.
If you disable recording for the call on line B (mode =
manual or auto start) and switch back to line A, the
recording for line A is not started again.
The modes mentioned (All Calls, AutoStart or Manual)
refer to the telephone and are therefore the same for all
lines.
1. Server-based conference only
Call recording
|
on the display
185