Transfer - Siemens HIPATH HIPATH 1190 User Manual

Step by step
>

TRANSFER ?

Optional (
TRANSFER ?
Speaker
1
Transfer
The Transfer feature allows an extension to transfer a
call (incoming or outgoing) to another extension or to an
external number.
Required: A call is in progress.
:
Select and press to confirm.
Enter the extension or external number.
) Let the caller know that there is a second call.
:
Press to confirm.
or
Replace the handset.
or
Press this key. The LED turns off.
External-to-External over an external analog line
When there is an external call in progress, an extension
can make a consultation to another external number
and transfer the call, as described above.
Once the call is transferred and answered at the desti-
nation, a disconnect timer is activated (default is 5 min-
utes). A 20-second warning tone is sent to both parties
before the call is disconnected. In order to continue the
call without disconnecting, the destination number
must enter a code (MF , default "00") to restart the time-
out., The call disconnect timeout and the Code to reset
it are configurable. Please ask your System Support
Technician for more information.
[1] If a transfer's destination extension does not answer, the call is re-
turned to the calling extension.
An External-to-External transfer can only be made when at least
one of the calls is an outgoing call.
A call cannot be transferred to an Entrance Telephone, neither can
an Entrance Telephone transfer a call.
A call can only be transferred to a busy extension if "Transfer when
Extension is Busy" feature is enabled (see Programming Manual -
Programming an Extension - Transfer when Extension is Busy). In
addition, this can only be carried out within the limitations specific
for "Urgent Call/Callback when Busy".
[2] A call is terminated under three conditions:
• Disconnect timeout after and external-to-external transfer (Code
183)
• When a busy signal is detected
• Type of Answering Signal (Code 158) detected.
Features used during Call
2
45