Parking A Call; Resuming A Parked Call - Siemens A30853 Operating Instructions Manual

27.11.98
Convenient and secure telephone communication

Parking a call

Resuming a parked call

18
kap01.fm5
You can temporarily park a call in order to
reactivate it at a later stage
resume it at another telephone
unplug your telephone from one socket and plug it
into another
The telephone must not be parked for more than three
minutes, as otherwise the call will be disconnected.
d
A call is in progress.
S04
Press the Programming key and enter the code "04" for
"Parking a call" .
The stored connection code is indicated on the display.
The connection code is a number under which the call
can be parked and later resumed.
If the call is to be parked under a different connection
code, the connection code must have been changed
beforehand (
Press the Programming key again and replace the hand-
S and b
set.
The call is now parked for a maximum period of 3 minutes.
A call can only be parked, if is connected to the
same S
You can resume a parked call from the same telephone or
from a different telephone (it must be connected to the
same S bus).
0
Prerequisite: A call is parked and you are not conducting a
call.
a
Handset is on-hook.
S04
Press the Programming key and enter the code "04" for
"Parking/resuming a call" .
The connection code is indicated on the display. If the call
was parked under a different connection code, change
the connection code beforehand (
S and c
Press the Programming key again and lift the handset.
You are now re-connected to the parked caller.
You can cancel a programming procedure
without making any changes by pressing the
Disconnect key
Profiset 30isdn engl.: A30853-X300-B107-1-7619
page 34).
bus.
0
page 34).
h
!