Programming The Telephone Settings; Password - Siemens A30853 Operating Instructions Manual

27.11.98

Programming the telephone settings

Programming the telephone settings

Password

28
kap01.fm5
Nearly all settings of your telephone (except parking a call,
input of the connection code and checking the settings of
the telephone) can only be programmed with the handset
on-hook (idle mode).
Programming procedures are started and exited with the
Programming key. A successful programming procedure
is concluded with a positive confirmation tone (
43). An unsuccessful programming procedure is conclud-
ed with a negative confirmation tone (
A programming procedure can be cancelled at any time
without making any changes via the Disconnect key.
A programming procedure is automatically cancelled if no
key has been pressed for longer than 1 minute.
When entering digits (e.g. the input of the MSN) the digit
entered last can be deleted via the Minus key.
You can define a password to protect against unauthor-
ized settings on your telephone. The password is a 4-digit
secret number. The following telephone functions can be
set without entering the password:
Handset volume
Ringer volume
Ringer melody
Park and resume a call
Display of own call number
Call waiting
All the other settings can only be activated after the pass-
word has been entered correctly.
All password-protected settings (except restoring the as-
supplied condition) are freely accessible in the as-sup-
plied condition (PIN 0000). Therefore, you should program
your individual password.
When you are entering the password, the digits you enter
are represented on the display as symbols only, for secu-
rity reasons.
a
Handset is on-hook.
S20
Start the programming procedure.
T
Enter the previous password.
T
Enter the new password twice (one after the other).
S
The new password is saved.
Profiset 30isdn engl.: A30853-X300-B107-1-7619
page 43).
page