Point-To-Point Protocol Over Atm (Llc Encapsulation) - Siemens 5890 User Manual

SIEMENS 5890 DSL Router
User's Guide

Point-to-Point Protocol over ATM (LLC Encapsulation)

If you selected Point-to-Point Protocol over ATM (LLC Encapsulation) from the Wan Interface page, the
Point-to-Point Protocol page is displayed when you click Next.
To configure Point-to-Point Protocol:
1. Enter PPP User Name and Password to use for authentication when establishing a WAN connection using
PPP protocol.
2. Select one or more of the following PPP Networking options:
•
Bridging Enabled:
Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can
optionally select Only bridge PPPoE traffic. If selected, only PPPoE traffic is bridged; all other traffic is
stopped.
3. IP Routing Enabled:
Route all IP traffic to remote hosts.
4. If you enabled IP routing, select one of the following methods for configuring IP routing:
•
Obtain configuration automatically from WAN
IP routing parameters are obtained from the WAN.
•
Configure IP Routing manually
IP routing parameters are set manually. If you select this options, you must the Source WAN IP
Address, Subnet Mask, and Default Gateway.
SIEMENS
Chapter 3 Easy Setup
Select Protocol
20