Table of Contents
Advertisement
Chapter 4: Web Configuration
Quick Start
The pages under the Quick Start menu provide user a quick way to set up the IAD. If
you do not know much about the router, you can use the Quick Start pages to adjust
basic settings to activate your IAD.
Connect to Internet
This is a quick way to connect to the
Internet by using PPPoE interface,
please click Connect to Internet to
open the web page.
Enter the user name and password
(that you get from the ISP) for your
IAD and click Connect.
The system will connect automatically,
and then you can access the Internet.
Quick Setup
The quick setup wizard will guide you
to configure this router through some
specific steps. Yet different connection
interface will lead to different setting
pages. Refer to the following pages for
detailed information.
Auto Scan Internet Connection
(PVC):
If there is no any PVC configured in
your router, you can check this item.
Otherwise, please uncheck this box.
VPI (Virtual Path Identifier):
Identifies the virtual path between
endpoints in an ATM network. The
valid range is from 0 to 255. To enter
the setting, please refer to the setting
that the ISP offered.
VCI (Virtual Channel Identifier):
Identifies the virtual channel endpoints
in an ATM network. The valid range is
from 32 to 65535 (1 to 31 is reserved
for well-known protocols). To enter the
setting, please refer to the setting that
the ISP gave you.
After entering the VPI/VCI value,
please click Next for the following
step.
61
Advertisement
Table of Contents
