Hach QbD1200 User Manual page 16

Configure the peripheral settings
1. Push Instrument Setup>Peripheral Settings.
2. Select an option.
Option
Printer Settings
Autosampler
Settings
Measurement
Do a measurement
1. Push Perform Measurement.
2. Select an option.
Option
Create New Tray
Load Tray From File
Manual Measurement
Select a Pre-Configured Tray
from List
3. Read the parameters of the selected tray, then make the necessary changes.
4. Push to start the measurement.
Make a sample tray template
1. Push Perform Measurement>Create New Tray.
2. Select the tray options. Push
Option
How many samples Sets the quantity of sample locations. When a sample location is selected for
How many reps
Sample ID label
Review & Confirm
3. Push Save to continue.
4. Enter a name for the tray template.
5. Push Save Tray to save the tray template.
6. Select "Make Default" to make this the default tray template.
7. Push to start the measurement.
If the samples are not prepared for the procedure, push Home.
16 English
Description
If a printer is connected to the instrument, push Add>Install. If more than one printer
is installed, set the default printer or remove a printer.
If an auto sampler is connected to the instrument push Autosampler Settings.
Select "Enable Autosampler", then select "Qbd1200 Autosampler". Push Save>Ok.
Description
Makes a new sample tray. Refer to
on page 16.
Imports trays from a USB flash drive that has sample tray parameters
set.
Sets up a manual measurement of one specified sample. Enter the
sample ID and the quantity of samples to replicate.
Selects a sample tray that is saved in the system to measure.
to go to the next screen.
Description
measurement, each sample location is identified with a blue circle.
Sets the quantity of sample replicates to measure (1 to 5).
Select how to identify each sample: individually, by an automatic sample ID with the
tray position with time stamps or with the sample ID builder.
Read the parameters of the tray. If necessary, make changes to the tray.
Make a sample tray template