Prime With Mortar Or Epoxy - Graco 262927 Instructions Manual

Prime with Mortar or Epoxy

Prime with with Mortar Mortar or or or Epoxy
Prime Prime with Mortar
NOTICE NOTICE NOTICE
To prevent material curing in system, never load
mortar into a dry system. Loading mortar into
a dry system will cause the mortar to stick to
internal components and cure causing damage
and requiring replacement of those parts.
The applicator nozzle or tip must be removed during
priming. Always push out any remaining "wet out"
fluid into a waste container before circulating mortar.
Always circulate clean mortar back into the hopper
for a few minutes before beginning to spray.
1. Wet out the system.
Wet Out the System, page
2. Mix the Material. See
3. Close the bleed type master air valve (B).
Figure 19
4. Remove tip from applicator.
20
Epoxy
Epoxy
See
16.
Mix the Material, page 19.
B
A
ti21575a
5. Fill the clean hopper with at least 4 gallons of the
material to be sprayed. If using 60 ft of material
hose, then fill with 6 gallons.
6. Turn air regulator adjustment knob (F)
counterclockwise until it stops and gauge (E)
reads zero.
Figure 20
7. Open the fluid ball valve (V) on the end of the
fluid hose.
8. Place applicator outlet in a grounded metal 5
gallon waste container.
9. Open the motor ON/OFF pilot ball valve (G)
located on base of applicator.
ti21571a
332612C