Setup - Graco 262927 Instructions Manual

Setup

Setup
Setup Setup
Tools Tools Tools Required Required Required
• Two adjustable wrenches
• Non-sparking hammer or plastic mallet
1. Ground sprayer. See
2. Check Throat Seal Liquid (TSL) level in packing
nut (R). Fill 1/2 full with TSL.
Figure 7
3. Attach 1 in. x 25 ft electrically conductive fluid
hose to pump outlet.
Note
NOTE: NOTE: The 3/4 in. hose will be NOTE:
connected to the end of the 1 in. hose at
the factory.
4. Attach large air line from hose bundle to main air
quick disconnect (N). See
5. Attach small air tube from hose bundle to motor
pilot signal (X). Use wrench to secure air tube in
place. See Details, page 9
6. Attach 3/4 in. hose to applicator fluid inlet.
7. Attach large air line from hose bundle to applicator
quick disconnect (W). See
8. Attach small air tube from hose bundle to
air motor pilot ball valve (G) on applicator.
Use wrench to secure air tube in place. See
Details, page 9 .
14
Grounding, page 13.
ti21631a
Details, page 9 .
.
Details, page 9 .
9. Wrap blue, velcro, camlock retaining straps
around each camlock connection to secure.
Note
NOTE: This includes the two camlocks
NOTE: NOTE:
between the hopper and pump lower, the
camlock at the pump outlet, the camlocks
on the fluid hoses, and the camlock on
the applicator inlet. The retaining straps
should be tight and must not be able to
slide off camlock.
10. Going from applicator back to the system, wrap a
zip tie around all hoses every few feet to secure
them together.
11. Connect air supply hose:
a. Close bleed type master air valve (B).
b. Expand end of whip check cable (Y) and
slide it over the end of your air hose.
c. Connect air supply hose to 3/4 npt(f) claw
fittings air inlet (A).
d. Install safety clips in claw fittings.
Figure 8
12. Wet out the system with material flushing agent
before using. See Wet Out the System, page
B
A
ti21575a
16.
332612C