Sherwood Newcastle R-963 Operating Instructions Manual page 33

Entering a video label
This function can be operated only on video input
sources such as VIDEO 1~5.
Select the desired video input source to
1
enter its label.
OSD
VIDEO OFF
or
Select the character on the flickering digit.
3
MULTI CONTROL
Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols: ( ) ＋ ， ． ￣ ／
Memorize the desired video label.
6
Correcting or clearing a video label
Select the desired video input source to be
1
rectified or cleared.
OSD
VIDEO OFF
or
POWER
POWER
33
Press the VIDEO LABEL button to enter the
2
video label mode.
Example) When selecting VIDEO 1.
VIDEO LABEL
Confirm your selection.
4
VIDEO LABEL
Then the next digit will flicker.
Repeat the above steps ③ and ④ to enter
5
the desired characters on the rest of the
digits.
On up to 9 digits, the desired characters can be entered.
Note: If any button such as "AUDIO", "VIDEO", "7.1
CH DIRECT" button, etc. is pressed while
entering a video label, the video label mode will
be canceled.
MEMO/ENTER
Repeat the steps ②~⑥ in "Entering a
2
video label" procedure.
To clear a video label, make a blank on each digit
and memorize it, then the video label is cleared and
its factory video input source will be displayed.
If the VIDEO LABEL button is pressed for more
than 3 seconds, blanks will be made on all the digits
at once.