Sherwood Newcastle R-963 Operating Instructions Manual page 15

Enter the 3 digit setup code aiming the
7
remote control at the REMOTE SENSOR on
the component.
OSD POWER
OFF
MAIN
CH/
SET
VOL CH
MUTE
AUTO DSP
For "001" :
7.1
SURR
RETURN
STEREO
1 3
2
4
6
5
7
9
8
DISC ROOM 2
DISP 0 ENT For "102" :
MI M2 M3
RNC-500
Your component will be turned off when the right
code is entered.
Continue to enter the corresponding codes until your
component turns off.
To resume the MAIN menu mode, press the
9
MAIN button twice briefly.
OSD POWER
OFF
MAIN
MAIN
CH/
SET
VOL CH
MUTE
AUTO DSP
7.1
SURR
RETURN
STEREO
1
3
2
4 6
5
7 9
8
DISC ROOM 2
DISP 0 ENT
MI M2 M3
RNC-500
Each time the MAIN button is pressed, the previous
mode is resumed.
Repeat the above steps ① to ⑩ for each of your other components.
11
0 0 1
1 0 2
The selected device
15
Confirm that it is the right code by pressing
8
the POWER button and then save the code.
OSD
OFF
The code is saved and the Pre-PROgramming mode
is resumed.
When you do not want to save the code, select the
EXIT on the LCD screen or press the MAIN button.
Operate the component using the
10
corresponding function buttons.
If any of the buttons fails to operate as they should,
start from the step ① again to enter the next setup code.
■Notes:
If the Manufacturer/Brand for your component is not
listed in "Set-Up Code Table" in the operating manual
of this remote control, please use the " 2 Auto Scan
Method" on page 13 in the operating manual of this
remote control.
Although each setup code is designed to work with
many different modes, certain codes may not work with
some models.( Also, certain codes may only operate
some of the functions available on a given model.)
POWER