Universal Remote Controls; Digi Link System Remote Controls - Sherwood Newcastle R-963 Operating Instructions Manual

Universal Remote Controls

Note: For enhanced Universal Remote Programming instructions and manufacturer's codes, please refer to the operating
manual inclosed with this Universal Remote Control.
This remote control unit has 3 operating modes as follows:
• OSD (On-Screen Display) mode: Allows you to look at information about basic operation of this unit on your monitor TV
• Sherwood mode: Allows you to operate this unit and other Sherwood components like cassette decks, CD players, etc.(To
operate other Sherwood components, you should make the DIGI LINK connections between them.)
• Non-Sherwood mode: Allows you to operate non-Sherwood audio and video components that are remote compatible.
Notes:
• The setup code for each component must be entered before operation.
• For setup codes(manufacturer's codes), please refer to "Set-Up Code Table" in the operating manual of this remote control.
• Some operation buttons have different functions according to each operation mode.
• Be sure to set the remote control to the correct mode before operation.

DIGI LINK SYSTEM REMOTE CONTROLS

• This section explains the basic functions for Sherwood or OSD mode. For the non-Sherwood mode, refer to the
operating manual of this remote control.
• All Sherwood components bearing the DIGI LINK(II or III) logo can be used with this remote control.
• For system remote control operation, first make the DIGI LINK connections between Sherwood components.
• The numbered buttons on the remote control have different functions in different modes. For details, refer to the
"FUNCTION TABLE of the NUMBERED BUTTONS" on the following page.
• In the DIGI LINK III remote control system, if pressing PLAY, etc. on CD player or tape deck, CD or TAPE
MONITOR is selected automatically on the receiver without selecting the input source. Then PLAY, etc. starts.
OSD BUTTON
LCD(FUNCTION) BUTTONS
MAIN BUTTON
Enters the MAIN menu mode
PAGE BUTTON
While displaying the page menu of the
selected device or the FAVORITE channel menu,
each time this button is pressed, its page changes
VOLUME UP/DOWN(+/-) BUTTONS
NUMERIC(1~0) BUTTONS
• For selecting preset stations in tuner mode.
• For selectiog a track or a disc in CD mode, etc.
• When selecting a disc, select disc No.(1~5)
within 2 sec.after pressing the DISC button.
MACRO BUTTONS
and to operate this unit by moving an arrow that appears on the screen of your monitor TV.
OSD
OFF
MAIN
AUDIO
CD VCR1
DVD VCR2
TAPE
AUX CABLE
AUDIO
MAIN
CH/
SET
VOL
MUTE
AUTO
RETURN
STEREO
1
2
4
5
7
8
DISC
0
DISP
MI M2
RNC-500
11
LCD SCREEN
POWER
POWER BUTTON
TV
LIGHT BUTTON
Activates the backlighting of the remote control
for a specified time(up to 99 sec.) If any other
button is pressed while the backlighting is on,
SAT
the remote control will remain backlit for an
additional period.
LCD(FUNCTION)BUTTONS
FAVORITE BUTTON
Enters the Favorite channel mode.
Each time this button is pressed, its page changes.
CH
CHANNEL LEVEL UP/DOWN
(+/-) BUTTONS
DSP
CURSOR CONTROL(
ENTER(
7.1
SURR
3
6
9
ROOM 2
ENT
M3
),
) BUTTONS