Sherwood Newcastle R-963 Operating Instructions Manual page 19

When CD, TAPE MON or VIDEO 1~
VIDEO 5 is selected
Select the digital or the analog input as
4
desired.
DIGITAL/ANALOG
or
Each time this button is pressed, the corresponding
input is selected as follows:
DIGITAL ANALOG
To listen to DTS, Dolby Digital or MPEG program
sources in the 2-CH downmix mode, in the stereo
mode, the digital input must be selected. (For details,
refer to "Downmixing into 2 front channels" on page
27.)
When PHONO, TUNER or AUX is selected as an
input source, the analog input is automatically selected.
■Notes:
When the selected digital input is not connected.
"DIGITAL" flickers, meaning no sound. (Refer to
"ENJOYING SURROUND SOUND" on page 24.)
To select the digital input, you must match the
connected DIGITAL IN to the corresponding input
source. (For details, refer to "When selecting the
DIGITAL IN SETUP" on page 41.)
Operate the selected component for
5
playback.
When playing back the program sources with
surround sound, refer to "ENJOYING SURROUND
SOUND" on page 24.
Adjust the (overall) volume.
6
MASTER VOLUME
or
DOWN
UP
POWER
OSD
OFF
POWER
OSD
OFF
MAIN
CH/
SET
VOL VOL CH
MUTE
AUTO DSP
7.1
SURR
RETURN
STEREO
1
3
2
4 6
5
7 9
8
DISC ROOM 2
DISP 0 ENT
MI M2 M3
RNC-500
19
Adjusting the tone (bass and treble)
Select the tone mode as desired.
7
TONE MODE
Each time this button is pressed, the tone mode
changes as follows:
BASS TREBLE
The tone display is shown for 5 seconds.
If the tone display disappears, press the TONE
MODE button again.
( ) : When the tone defeat function is activated
("DEFEAT ON"), bass and treble modes cannot be
selected
■Note:
When the source direct function is activated, the
tone mode cannot be selected.
At the desired tone mode, adjust as
8
desired.
MULTI CONTROL
■At the tone defeat mode, each time the MULTI
CONTROL knob is rotated, the tone defeat mode
changes as follows:
DEFEAT ON : When listening to a program source
↕
without the tone effect.
DEFEAT OFF : When adjusting the tone for your
taste.
■At the desired tone (bass or treble), each time the
MULTI CONTROL knob is rotated, the tone level
can be adjusted within the range of +10~ -10 dB.
In general, we recommend the bass and treble to be
adjusted to 0(flat) level.
To complete tone adjustment, repeat the above steps
⑦ and ⑧.
Extreme settings at high volume may damage your
speakers.
DEFEAT OFF(or ON)