Sherwood Newcastle R-963 Operating Instructions Manual page 29

Select the desired preset number(1~30)
3
and press the MEMORY/ENTER button.
TUNING/PRESET
When using the NUMERIC buttons on the remote
control.
Examples)
For "3" :
3
within 2 seconds
For "15" :
1 5
For "30" :
0
The station has now been stored in the memory.
When using the NUMERIC buttons, the station is stored
automatically without pressing the MEMORY/ ENTER
button.
A stored frequency is erased from the memory by storing
another frequency in its place.
If "MEMO" goes off, start again from the above step ②.
Tuning to preset stations
After selecting the tuner as input source,
1
select the preset tuning mode.
T/P MODE
Then "PRESET" lights up.
Scanning preset stations in sequence
OSD
OFF
MEMO/ENTER
POWER
29
Repeat the above steps ① to ③ to
4
memorize other stations.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned
off, are memorized.
INPUT SELECTOR settings
Surround mode settings
Preset stations, etc.
Note : If the electricity fails or the AC input cord is
disconnected for about 2 weeks, all
memorized settings will be lost.
Select the desired preset number.
2
TUNING/PRESET
When using the NUMERIC buttons on the remote
control.
Examples)
For "3":
3
within 2 seconds
For "15":
1 5
within 2 seconds
(or
For "30":
0 3
When selecting the desired preset number with the
NUMERIC buttons, the desired preset station will be
tuned to automatically without selecting the preset
tuning mode.
The receiver will start scanning the stations in the
preset sequence and each station is received for 5
seconds.
At the desired station, press this button again to
stop scanning.
)
0