Setting The Room2 Feed Setup - Sherwood Newcastle R-965 Operating Instructions Manual

SETTING THE ROOM2 FEED SETUP

R O O M 2 F E E D S E T U P
V O L U M E MO D E :
R O O M 2 F E E D :
T U N E R V I D E O
C D V I D E O
A U X V I D E O
P H O N O V I D E O
V I D E O
V I D E O
R E T U R N : B a c k ,
• The ROOM 2 function allows enjoying one source in the main room while playing another in a different room at the same time.
• The analog signals from the 8 CH DIRECT inputs and TAPE MONITOR INs cannot be output from the VIDEO 2 / ROOM 2
(audio) OUTs.
When selecting the VOLUME MODE
Press the CURSOR UP( )/DOWN( ) buttons to select the VOLUME MODE.
1
STANDBY
MAIN
VOL
MUTE
DECODE
DSP
RETURN
STEREO
1
2
4
5
7
8
0
DISP
MI M2
Press the CURSOR LEFT( )/RIGHT( ) buttons to select the desired volume mode for the ROOM 2
2
source.
STANDBY
MAIN
VOL
MUTE
DECODE
DSP
RETURN
STEREO
1
4
7
DISP
MI M2
RNC-510
Notes :
• When you assign the power amplifier for the surround back channels to the ROOM 2, the volume mode is
automatically set to Variable.
• In case that an integrated amplifier, etc. is connected to the VIDEO 2/ROOM 2(audio) OUTs and the volume
mode is set to Variable, if the ROOM 2 volume level is adjusted to high level on both this receiver and the
connected amplifier, the ROOM 2 speaker and the connected amplifier may be damaged.
Therefore, be sure to set the volume mode to Fixed for safe operation when using amplifier with its own volume
control for ROOM2.
• When selecting the Fixed mode, first adjust the volume level as desired in the Variable mode and select the Fixed
mode. Then the volume level will be fixed to the adjusted level.
To select the desired volume mode.
Variable
Off To select the desired ROOM 2 source.
1
2
3
4
5
6
: S e l e c t
POWER ON
CH.
SET
CH/
ADJUST
DSP
3
6
9
OSD/MENU
ENT
M3
POWER ON
CH.
SET
CH/
ADJUST
DSP
3
2
6
5
9
8
OSD/MENU
0 ENT
M3
• Each time these buttons are pressed, the volume mode
changes as follows:
Variable : Select this when an power amplifier is connected
to the VIDEO 2/ROOM 2(audio) OUTs for ROOM
2 source playback. You can adjust the ROOM 2
volume level with the MASTER VOLUME
CONTROL knob of this receiver or the VOLUME
UP/DOWN buttons on the remote control.
Fixed : Select this when an integrated amplifier, etc. is
connected to the VIDEO 2/ROOM 2(audio) OUTs.
You can adjust the ROOM 2 volume level on the
connected integrated amplifier, etc.
66