Setting The Power Amp Assign; Setting The Speaker Setup - Sherwood Newcastle R-965 Operating Instructions Manual

SETTING THE POWER AMP ASSIGN

• You can assign the power amplifier for the surround back channels to the ROOM 2.
In this case, you need not use the power amplifier to drive the speakers additionally in a different room (ROOM 2).
P O WE R A MP A S S I G N
S / B A C K
ROO M 2
R E T U R N : B a c k ,
Press the CURSOR LEFT( )/RIGHT( ) buttons to use the power amplifier as desired.
STANDBY POWER ON
MAIN
CH.
SET
CH/
VOL
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510

SETTING THE SPEAKER SETUP

• After you have installed this unit and connected all the components, you first perform the speaker setup settings for the optimum
sound acoustics according to your environment and speaker layout.
• Even when you change speakers, speaker positions, or the layout of your listening environment, you should perform the speaker
setup settings, too.
• When performing the AUTO SPEAKER SETUP procedure, you need not perform the SPEAKER CONFIGURATION, SPEAKER
DISTANCE and CH LEVEL SETUP procedures.
S P E A KE R S E T U P
S P E A K E R C O N F I G U R A T I O N
S P E A K E R D I S T A N C E
V I R T U A L S P E A K E R
S U B W O O F E R : A C T I V E
S U B W O O F E R M O D E : L F E
C R O S S O V E R F R E Q . : 8 0 H z
A U T O S P E A K E R S E T U P
R E T U R N : B a c k E N T E R : S e l e c t
When selecting the SPEAKER CONFIGURATION
Press the CURSOR UP( )/DOWN( ) buttons to select the SPEAKER CONFIGURATION, then press
1
the ENTER button.
STANDBY
VOL
DSP
RETURN
1
4
7
DISP
MI
: S e l e c t
• Each time these buttons are pressed, the power amplifier is
assigned as follows :
S /BACK : Select this to use power amplifier for the surround back
ROOM 2 : Select this to use it for the ROOM 2.
To select the sizes of the speakers that are connected.
To enter the distance between the listening position and each speaker to set
the delay time automatically for the optimum surround playback.
S E T U P
To adjust the Dolby Virtual Speaker setting modes as desired.
To select the type of the subwoofer that is connected.
To select the desired subwoofer mode.
, : M o v e To select the desired crossover frequency.
To set the speaker setup and channel level setup automatically.
POWER ON
MAIN
CH.
SET
CH/
ADJUST
MUTE
DECODE
DSP
STEREO
3
2
6
5
9
8
OSD/MENU
0
ENT
M2 M3
RNC-510
channels.
S P E A K E R C O N F I G U R A T I O N
S U B W O O F E R :
F R O N T
C E N T E R
S U R R . A / B
S U R R . ( A )
S U R R . ( B )
S / B C H
S U R R . B A C K :
R E T U R N : B a c k ,
45
Yes
Large
:
: Large
: A + B
: Large
: Large
:
2CH
Large
: S e l e c t