Sherwood Newcastle R-965 Operating Instructions Manual page 34
Sherwood a/v receiver operating instructions
Hide thumbs
Also See for Newcastle R-965:
- Brochure & specs (6 pages) ,
- Upgrade manual (5 pages) ,
- Brochure (4 pages)
Table of Contents
Advertisement
Adjust the level of the selected channel as
2
desired.
or
DOWN
UP
Adjusting the Dolby Pro Logic IIx / Dolby Pro Logic II Music parameters
• When selecting either the Dolby Pro Logic IIx Music mode or the Dolby Pro Logic II Music mode depending on
whether "S/B CH" is set to "None" or not, you can adjust the various surround parameters for optimum surround
effect.(Refer to "When selecting the SPEAKER CONFIGURATION" on page 45.)
• In case of PL IIx MUSIC mode, only when original surround mode is "BYPASS" mode or 2 channel digital
signals from Dolby Digital sources, etc. are input, these parameter settings affect the surround effects.
Press the DOLBY PL II MUSIC PARAMETER button to select the desired parameter.
1
STANDBY
SLEEP
DIMM
ROOM2
or
T.TON
OSD
At the desired parameter, adjust it as desired.
2
or
• If the parameter display disappears, start from the
step
again.
STANDBY
POWER ON
MAIN
CH.
SET
CH/
VOL
CH/
ADJUST
MUTE
ADJUST
DECODE
DSP
DSP
RETURN
STEREO
1
3
2
4
6
5
7
9
8
OSD/MENU
DISP
0
ENT
MI
M2
M3
RNC-510
• Each time this button is pressed, the parameter changes and is
displayed for several seconds as follows;
Panorama mode("PANORAMA", default value : OFF)
This mode extends the front stereo image to include the
POWER ON
surround speakers for an exciting "wraparound" effect with
AUD2
D/A
side wall imaging. Select "OFF" or "ON".
S.A/B
SUR.B
Center width control("C-WIDTH", default value : 0)
PURE
PARA.
This adjusts the center image so it may be heard only from the
PAGE1
center speaker, only from the left/right speakers as a phantom
image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dimension control("DIMENSION", default value : 0)
This gradually adjusts the soundfield either towards the front
or towards the rear. The control can be set in 7 steps from -3
to +3.
STANDBY
POWER ON
MAIN
CH.
SET
CH/
VOL
CH/
ADJUST
MUTE
ADJUST
DECODE
DSP
DSP
RETURN
STEREO
1
3
2
4
6
5
7
9
8
OSD/MENU
DISP
0
ENT
MI
M2
M3
RNC-510
34
Repeat the above steps
3
each channel level.
Repeat the above steps
3
adjust other parameters.
and
to adjust
and
to
Hide quick links:
Advertisement
Table of Contents
