Operating Components With Remote Control; Remote Control Operation Range; Loading Batteries - Sherwood Newcastle R-965 Operating Instructions Manual

OPERATING COMPONENTS WITH REMOTE CONTROL

Enter the setup code of the components
1
respectively, referring to "ENTERING A
SETUP CODE" (page 21).
Turn on the components you want to
2
operate.
Select the device on the main menu of the
3
remote control corresponding to the
component you want to operate.
Example) When selecting "AUD 1" or "AUD 2" to
operate this receiver.
POWER ON
STANDBY
MAIN
AUD1 AUD2
CD TV
DVD VCR
TAPE SAT
AUX CABLE
AUD1
• Then the page menu of the selected device will be
displayed.
Press the button corresponding to the
4
operation you want while aiming the
remote control at the REMOTE SENSOR
on the component.
• When operating a Sherwood CD player or tape deck
using the system remote control, aim the remote
control at the REMOTE SENSOR on this unit.
• However, in case of Sherwood DVD player or TV,
aim it at the REMOTE SENSOR on the
corresponding component.
In case of selecting a function on the page menu of
the selected device.
• Find a function with pressing the PAGE button
repeatedly and then press the button corresponding
to the desired function.
Example) when selecting a function on the AUD 1's
page menu.
Functions on the page 1
AUD1
TUNER VID1
CD VID2
T.MON VID3
AUX VID4
PHONO VID5
PAGE1
The device selected presentl
Functions on the page 2
AUD1
VID6 7.1IN
DTS PL2MV
DOLBY PL2MS
PCM NOE6C
MPEG NEO6M
PAGE2
20

REMOTE CONTROL OPERATION RANGE

• Use the remote control within a range of about 7
meters (23 feet) and angles of up to 30 degrees
aiming at the remote sensor.
POWER ON
STANDBY
MAIN
CH.
SET
VOL CH/
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1
3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510

LOADING BATTERIES

When the remote control does not operate or "LOW
BATTERY" is displayed on the LCD screen, etc., the old
batteries should be replaced.
Remove the cover.
1
Load four alkaline batteries ("AAA" size,
2
1.5V) matching the polarity.