Connector; Figure 2. Data/Power Connector; Table 4. Connector Pinouts - Planar ICEBrite EL640.200-SK Series User Manual

Connector

Video signals and DC power are connected to the display through a 24-contact
dual-row 2 mm square pin locking connector, Samtec EHT-112-01-S-D. The
mating connector is available through Samtec as an IDC cable assembly (Series
TCSD-12-S-XX-01-X-X). The proper connector, user-specified cable length, and
connector configuration are supplied as a single unit. Consult your Samtec
representative (1-800-SAMTEC9) for cable and connector options.

Figure 2. Data/Power Connector.

Table 4. Connector Pinouts.

Pin
1
3
5
7
9
11
13
15
17
19
21
23
8 EL640.200-SK Operations Manual (020-0348-00B)
(Viewed from electronics side of display)
Pin 1
Key
Signal Description
VID1 (U1) Video Data
VID3 (U3) Video Data
VID (L3) Video, Lower Panel
VID (L1) Video, Lower Panel
VCLK Video Clock
HS Horizontal Sync
VS Vertical Sync
Selftest Selftest Input
VL (+5V) +5 V Power
VH (+12V) +12 V Power
LUM 0 Digital dimming
GND Ground
(Viewed from top of connector)
Pin 2
Pin 1
Pin Signal
2 VID0 (U0)
4 VID2 (U2)
6 VID (L2) Video, Lower Panel
8 VID (L0) Video, Lower Panel
10 GND
12 GND
14 GND
16 GND
18 VIDMODE Selects video mode
20 VH (+12V)
22 LUM1
24 LUMA Analog dimming input
Key
Description
Video Data
Video Data
Ground
Ground
Ground
Ground
+12 V Power
Digital dimming