Calibrate - Hach TSS sc User Manual

Operation
4.4.2 SENSOR setup
SELECT SENSOR (if there is more than one sensor)
TEST/MAINT
PROBE INFO
SENSOR NAME
EDITED NAME
SERIAL NUMBER
TURBIDITY
SOLID
MODEL NUMBER
CODE VERS
PROFILE
PROFILE COUNTER
RESET CONFIG
COUNTERS
INTERVAL
SERVICE
WIPE
SIGNALS
S5E1
S5E3
S6E1
S6E3
S5E2
S5E4
S6E2
S6E4
SET OUTMODE
HOLD
ACTIVE
SET TRANSFER
SELECTION
4.5

CALIBRATE

20
Device name
0,001 to 9999 FNU
0,001 to 500 g/L
Item no. Sensor
Sensor software
Counter 20,000 backwards
MANUAL RESET, security prompt
MANUAL RESET. PRESS ENTER: security prompt
TEST/MAINT: COUNTER X DAYS BACKWARDS,
GASKET (GASK.): COUNTER X DAYS BACKWARDS,
TOTAL: OPERATING HOURS COUNTER,
MOTOR: WIPE CYCLE COUNTER
Default for maintenance counter
Explanation: refer to service manual
Equipment output behavior in the SERVICE menu
Service access
Note: Turbidity measurement has been calibrated by the manufacturer — it does not need to be
calibrated again.
Note: It is imperative to calibrate for solid matter measurement (refer to section
the SOLID (TS) parameter).
The zero point for turbidity and solid matter measurement has been set in the sensors by
the manufacturer.
4.5.2 Calibration of