Section 4 Operation; User Interface And Navigation; Sensor Setup; Sensor Data Logger - Hach TSS sc User Manual

Section 4
4.1

User interface and navigation

4.2

Sensor setup

4.3

Sensor data logger

4.4

Menu structure

4.4.1

SENSOR STATUS

SELECT SENSOR (if there is more than one sensor)
ERROR LIST
WARNING LIST
Operation
The sensor can be operated with all sc controllers. Refer to the controller documentation
for keypad description and navigation information.
When the sensor is connected for the first time, the sensor serial number is displayed as
the name of the sensor. To change the sensor name:
1. Open the·MAIN MENU.
2. Select SENSOR SETUP and confirm.
3. Select the corresponding sensor and confirm.
4. Select CONFIGURE and confirm.
5. Select EDIT and confirm.
6. Edit the name and confirm to return to the CONFIGURE menu.
Complete sensor configuration in the same manner, with the following menu options
selected:
• MEAS UNITS
• PARAMETERS
• CLEAN. INTERVAL
• RESPONSE TIME
• LOGGER INTERVAL
7. Go back to the MAIN MENU or the measurement mode display.
There is a data log and event log available for each sensor. The data memory is used to
store measurement data at preset intervals; the event memory stores events such as
configuration changes, alarms and warning conditions. Both logs can be exported to CSV
format (refer to the controller manual).
Possible error messages: MEAS OVERRANGE, CAL. INSUFF. +/–, ZERO, CAL REQUIRED, EE
RSRVD ERR, ERROR PROBE, LED FAILURE
Possible warning messages: REPLACE PROFILE, TEST/MAINT, GASKET
Note: Refer to Section 6 Troubleshooting
together with a description of all necessary countermeasures to be taken.
for a list of all possible error and warning messages
17