Sensor Setup - Hach TSS sc User Manual

Operation
4.4.2

SENSOR setup

SELECT SENSOR (if there is more than one sensor)
WIPE
CALIBRATE (turbidity)
SET OUTMODE
HOLD
ACTIVE
SET TRANSFER
SELECTION
SENSOR MEASURE
FACTOR
OFFSET
CALIBRATE
MEMORY
POINT 1
POINT 2
POINT 3
CLEAR MEMORY
POINT 1
POINT 2
POINT 3
SET CAL DEFLT
CALIBRATE (TS content)
SET OUTMODE
HOLD
ACTIVE
SET TRANSFER
SELECTION
SENSOR MEASURE
FACTOR
CALIBRATE
MEMORY
POINT 1
POINT 2
POINT 3
CLEAR MEMORY
POINT 1
POINT 2
POINT 3
SET CAL DEFLT
18
Triggers a wiping operation
Behavior of the outputs during calibration and zero point adjustment
Current, uncorrected measurement value
Can be set from 0,10 to 10,00; a detailed description is provided in section
CALIBRATE
Can be set from -100 to +100, a detailed description is provided in section
CALIBRATE
Calibration point 1 is recorded
Calibration point 2 is recorded
Calibration point 3 is recorded
Clears the recorded values for all points.
Current calibration for point 1
Current calibration for point 2
Current calibration for point 3
Security prompt, reset to default calibration
Behavior of the outputs during calibration and zero point adjustment
Current, uncorrected measurement value
Can be set from 0,10 to 10,00; detailed description in section
Calibration point 1 is recorded
Calibration point 2 is recorded
Calibration point 3 is recorded
Clears the recorded value for all points.
Current calibration for point 1
Current calibration for point 2
Current calibration for point 3
Security prompt, all calibration points are cleared
4.5
4.5
4.5 CALIBRATE