Mitsubishi FX2NC DSS Series Hardware Manual page 75

FX2NC Series Programmable Controllers
Figure 3.15:Specifications of terminal block tightening screwdriver
0.4
mm
(0.016)
( ):inches
Figure 3.16 :Outline drawing of ferrule with insulating sleeve
(manufactured by PHOENIX CONTACT)
Contact area
2.6mm
(0.1)
Insulating
sleeve
( ):inches
Point of contact of PHOENIX CONTACT:
Web page http://www.phoenixcontact.com/
Use a small commercial screwdriver of the size shown on the left.
Screwdriver
Make sure that the tip is straight, and is not broadened.
with straight
tip
Recommended dedicated screwdriver:
2.5mm
Model SZS 0, 4 × 2, 5 (manufactured by PHOENIX CONTACT)
(0.1)
• Recommended ferrule: Model AI 0, 5-8WH
• Caulking tool: CRIMPFOX UD6
8mm
A cable may not be smoothly inserted into the insulating sleeve if
(0.3)
the sheath of the cable is thick. Select a proper cable while
14mm
referring to the outline drawing.
(0.6)
Installation notes 3.
3-19