Switching From Noe To Sip Mode - Alcatel-Lucent IP Touch 4008 Installation Manual

Firmware version identification – phone already installed.
1- Power on the phone.
2- At the phase 2/5 network setup, press the "i" key and just after the "#" key.
3- '0 - MAC address' menu appears.
4- Scroll down to '2 - Soft infos'.
5- Press the OK key.
6- Scroll down to 'Run mode':
- if NOE is displayed, it means that the NOE signaling protocol is running,
- if SIP is displayed, it means that the SIP signaling protocol mode is running.

Switching From NOE To SIP Mode

3.2.
There are two methods.
Method 1 - Manual
1- Power on the phone.
2- At the phase 2/5 network setup, press the "i" key and just after the "#" key.
3- '0 - MAC address' menu appears.
4- Scroll down to '2 - Soft infos'.
5- Press OK.
6- 'Version NOE x.xx.xx' is displayed.
7- Scroll down to 'Run mode', 'Set Mode: NOE' is displayed.
8- Press OK to switch from NOE to SIP mode.
9- Press '#' to save the new configuration.
10- Press the Hang Up key to reset the device to take into account the new configuration.
For checking SIP status, follow 'Firmware version identification already installed' section.
All Rights Reserved © Alcatel-Lucent 2010
Page 5