Net Log - Alcatel-Lucent IP Touch 4008 Installation Manual

Terminal Port
1 auto-negotiation
2 auto-negotiation
3 auto-negotiation
4 auto-negotiation
5 auto-negotiation
6 100-FULL
7 100-FULL
8 100-FULL
9 100-FULL
10 100-HALF
11 100-HALF
12 100-HALF
13 10-FULL
14 10-FULL
15 10-HALF
Note 2: to prevent slowness problem on PC when the two ports of the IP Touch 4018EE phone are
configured in auto-negotiation mode, if the negotiation has led to a 10 Mbps rate on the PC port and a
100 Mbps rate on the LAN port, the IP Touch set automatically tries to renegotiate a 10 Mbps rate on the
LAN port.

Net log

4.4.
The 'netlog' function allows configuring a network syslog server on which the debug flux will be
sent. It also allows setting the debug flux level and enabling or disabling the debug link.
In order to activate this net log function, telnet service must be available.
On administrator console, type telnet SIP phone IP @
Telnet window appears. Enter telnet password (password stored in sipconfig.txt or sipconfig-
mac@.txt).
All Rights Reserved © Alcatel-Lucent 2010
Table 3: Ethernet link combinations
External Device Port
auto-negotiation
100-FULL
100-HALF
10-FULL
10-HALF
100-FULL
100-HALF
10-FULL
10-HALF
100-HALF
10-FULL
10-HALF
10-FULL
10-HALF
10-HALF
Link Status
Valid
Invalid (packet loss)
Valid
Invalid (packet loss)
Valid
Valid
Invalid (packet loss)
Invalid (no link)
Invalid (no link)
Valid
Invalid (no link)
Invalid (no link)
Valid
Invalid (packet loss)
Valid
Page 27