Connecting The Ip Touch 40X8 Ee Phone To The Lan; Connecting Power Supply; Plugging A Pc To An Ip Touch 4018 Ee Phone; Sip Stand-Alone Mode - Alcatel-Lucent IP Touch 4008 Installation Manual

Connecting the IP Touch 40x8 EE phone to the LAN

2.1.
To connect the set to the LAN:
1. Turn the set over
2. Plug the RJ45 cable into the set LAN connector
3. Connect the RJ45 cable to the LAN itself

Connecting power supply

2.2.
The following procedure does not apply when power supply is provided via Power over Ethernet
(PoE).
To supply power via an AC/DC external adapter:
1. Plug the appropriate cable into the set power supply connector
2. Connect the plug to the power supply. Initialization starts.

Plugging a PC to an IP Touch 4018 EE phone

2.3.
Only one additional equipment can be connected to the set connector labeled PC on an IP Touch
4018 EE phone.
Note 1: reminder, the Alcatel-Lucent IP Touch 4008 EE phone set has no PC connector.
Note 2: if 802.1x authentication is used, the PC port cannot be used until the IP Touch 418 EE
phone authentication is completed.

3. SIP stand-alone mode

Firmware version identification

3.1.
In addition to existing call processing support for the Alcatel-Lucent OmniPCX™ Communication
Servers (NOE signaling protocol), the Alcatel-Lucent IP Touch 40x8EE phone can also be
configured as Session Initiation Protocol (SIP) endpoints and, therefore, operate in a standard SIP
environment. The Alcatel-Lucent IP Touch 40x8 EE phone may also switch to SIP survival mode in
SIP standalone mode.
Firmware version identification – phone out of the box.
In this context, the phone is natively configured in NOE mode
1- Power on the phone.
2- At the phase 2/5 network setup, press the "i" key and just after press the "#" key.
3- '0 - MAC address' menu appears.
4- Scroll down to '2 - Soft infos'.
5- Press the OK key.
6- The version is displayed : 'Version NOE 4.xx.xx'. If the version is at least 4.xx.xx, SIP boot
mode is possible.
All Rights Reserved © Alcatel-Lucent 2010
Page 4