Uniden Polaris Owner's Manual page 12

UT888ZL (POLARIS)-0708
Triple Watch
Triple Watch monitors Channel 16 and Channel 9 for activity every two
seconds while scanning or monitoring.
To activate Triple Watch, press 16/9/TRI key for 2 seconds. The "TRI "
icon appears on the LCD panel, indicating Triple Watch mode is effect. If
a signal is received on either Channel 16 or Channel 9, the radio
remains on that channel unit the signal ends.
Press and hold 16/9/TRI key for 2 seconds to cancel Triple Watch Mode
Note: Rewriting of priority CH cannot be performed.
It is set to Triple watch which receives 16CH, 9CH, and Current
CH when a signal is in Current CH. It is set to Dual watch
which receives 9CH and 16CH when a signal is in 9CH.
When a signal is in 16CH, it stops at this CH, and gives priority
and receives.
If Triple watch is in WX mode, Triple watch will start with WX
mode.
If 16/9/TRI key is pressed for 2 seconds in scan mode, normal
scan and Triple watch scan will change.
If user presses 16/9/TRI key in Triple watch mode, Triple watch
will be interrupted temporarily and it will be set to PRI 16CH. If
user presses 16/9/TRI key once again, it will be set to PRI
9CH, and Triple watch will be resumed if user presses 16/9/TRI
key once again.
Triple watch is not turned on or turned off while WX ALERT
beep is sounding, or while receiving WX ALERT CH, even if
user presses 16/9/TRI key for 2 seconds.
Manual Tuning (scan mode?)
To manually select a channel, rotate the channel knob (push-select)
clockwise to increase the number or counterclockwise to decrease the
number and select the desired channel. Communication channels are
located on channel 01-28 and 60-88. Weather channels are located on
channels 0-9.
7/8/02 8:13 PM Page 9
TRI HI CAN
MEM
9
SC